Hello everyone,
Just a quick question, I have an Ocar resin body that I previously painted and am wanting to re-paint it as I think I can make a better job of it now.
However I am not sure of the best way around it. Do I strip the paint back, clean and start from the beginning? If so what would I need to do this without damaging the body.
Is it better to just put the new colour on top of what is already there? I'm thinking this wouldn't be so good as the final colour might be affected by what's underneath.
Thirdly and most long winded, I could make a mould from the original painted one and make a new cast in resin and simply paint that instead. I think a bit too much effort is involved in this last one though.
If anyone out there knows, particularly on the first two options I'd appreciate your input.
Many Thanks
Alex
Just a quick question, I have an Ocar resin body that I previously painted and am wanting to re-paint it as I think I can make a better job of it now.
However I am not sure of the best way around it. Do I strip the paint back, clean and start from the beginning? If so what would I need to do this without damaging the body.
Is it better to just put the new colour on top of what is already there? I'm thinking this wouldn't be so good as the final colour might be affected by what's underneath.
Thirdly and most long winded, I could make a mould from the original painted one and make a new cast in resin and simply paint that instead. I think a bit too much effort is involved in this last one though.
If anyone out there knows, particularly on the first two options I'd appreciate your input.
Many Thanks
Alex
